Currently there are many self-leveling coatings manufacturers and construction engineering company, but in the end self-leveling floor quality differences evident in this application based on our many years of experience in providing some practical engineering experience to our customers and end users to evaluate engineering situations:
Surface Condition: As a highly decorative surface leveling coatings, requires self-leveling with good flatness, and should not have bubbles, debris and other adverse conditions.
Plumpness: In the past, OLED Module many domestic manufacturers are basically self-leveling without this technical indicators, but in Japan and other countries is a basic technical indicators, we usually use reflective indicators to measure the rate of a full degree, we require good curing artesian flat surface reflectivity of 95%, and we are currently on many domestic manufacturers of products for testing showed that the reflectance of less than 85%, resulting in brightness is not high, it is the above-mentioned technical guiding ideology differences due to differences in addition to the above, the fullness bad as the emergence of a self-leveling surface of the egg, "Songhua" floral shapes, facing the light side, you will find the surface layer of fog blurred like oil. Based on our many years of experience in engineering, a relatively quick visual method is to turn the switch case, if plumpness good floor, the top of the fluorescent lamp (commonly known as "fluorescent") pipe in the ground without clear projection of aerodromes phenomenon will occur out of shape; while in the case of poor plumpness, lamp projection images are blurred, distorted.
Hardness: lcd module As floor, requiring the floor surface after curing certain hardness to achieve sufficient resistance to abrasion, self-leveling coating filler will sink after curing the hardness of the ground floor is not too high, generally require floor hardness> 2H, to meet industry requirements.
没有评论:
发表评论